Loading
Preparing the page.
Design split bars with automatic support detection, editable margins and control over the cement gap.
Work directly on your hybrid. Detect supports, define the margin and refine the bar in one workflow, then review and export the split.
Open appPick an implant interface on the scan or detect the supports together. Draw the margin on the surface, then refine the separator before the split.
File requirements and workflow guideTwo ways to identify the implant interfaces and tooth supports. Pick a shaft on the model for guided detection, or run the automatic search and review them together.
Click inside a screw shaft. The detector works from the point you pick.
Search the hybrid for screw shafts and prepared tooth supports in one action.
Draw a closed line on the hybrid to define the bar boundary. The curve follows the surface; its points remain editable.
Screw shafts and prepared tooth supports are searched in the same action.
Correct detected supports, move the margin line and refine the separator.
Adjust the cement gap and the tighter clearance at the margin before cutting.
Yes. Split bar is available in beta with operator support.
No. Use the automatic search to detect screw shafts and prepared tooth supports together. You can also pick a shaft individually and run detection at that point.
Yes. Review the detected supports before continuing, and adjust any that need attention.
Yes. The curve follows the hybrid surface and its points remain editable.
Set the clearance before the split, including the tighter clearance at the margin. Review both parts before exporting.
The bar and its matching counterpart as separate files. Inspect the final geometry before manufacturing.
