Fix an uncertain alignment
Leave stray material out and set the lower jaw roughly in place, then run again.
- In the result panel, press Edit preparation.
- With Manual Brush A, paint over scan markers and flaps.
- Under Bite, press Adjust bite B.
- In the 3D view, drag the lower jaw roughly into the bite.
- Press Run C.
The bite search starts from your position.
Tip
- Alignment uncertain means the search is not sure of this bite.
- Still uncertain? Press Report a bug at the bottom left of the case.
Caution
- Do not design on an Alignment uncertain bite until you have checked it yourself.

