Check and fit the contacts
Colours show where the crown presses in. One press fits it to the bite and neighbours.
- In the Crown window, press Contacts.
The contact tools open under the crown tools.
- Press Antagonist A to check the bite.
The picture B shows the closest distance, in mm.
- Press Distance C.
Red presses into the opposing teeth; green to blue has room.
- Press Adapt all contacts D.
The crown meets the set touch. The red spots are gone.
- Press Neighbours E to check the side contacts.
Colours show only where the crown meets each neighbour.
- Press Done.
Tip
- One Undo brings back the design from before Adapt all contacts.
More
- The number under the picture: how hard the crown meets the other tooth. Below 0 it presses in, 0 touches, above 0 leaves room.
- − and + change it by 0.01 mm. You can also drag the tooth in the picture closer or away. Default marks your preset's value.
- Distance scale: −0.25 to 1 mm. Red is below 0, green to blue is room.
- Cut contacts: cuts the crown back where it presses into the opposing teeth. Gaps are not filled.
- Fit neighbours: closes the gap to each neighbour and cuts back where one presses on the crown.
- Close gaps: the fit also fills gaps to the neighbours. Gum line: the crown stays as it is below the neighbour's gum line.

