Set thickness and cement gap
Four numbers set the crown wall and the room inside. The crown refits when you let go.
- In the Crown window, press Gap A.
The Thickness and cement gap window opens beside the crown.
- Minimum thickness C: the thinnest the crown wall may be.
- Cement gap D: room for cement over the walls and the top.
- Extra room E: added everywhere, margin included, for scan and milling error.
- Tight band at margin F: how far up from the margin the crown fits tight.
- Drag a slider or type a number, then let go.
The inner surface rebuilds. A made crown is fitted again, its form kept.
Tip
- Point at a value and its zone lights up in the crown-cut picture B. The room inside is drawn enlarged.
- Preset values G puts every value in this window back to the order's preset.
Caution
- Keep Minimum thickness at or above the material value: zirconia 0.6 mm, lithium disilicate 0.5 mm. A thinner wall can break.
More
- Zirconia: Minimum thickness 0.6 mm, Cement gap 0.06 mm, Extra room 0.02 mm, Tight band at margin 1.0 mm.
- Lithium disilicate: Minimum thickness 0.5 mm, Cement gap 0.06 mm, Extra room 0.02 mm, Tight band at margin 1.2 mm.
- Printed resin, permanent or temporary: Minimum thickness 0.8 mm, Cement gap 0.08 mm, Extra room 0.02 mm, Tight band at margin 1.0 mm.
- Inside the tight band the only room is Extra room. Above it the room is Cement gap plus Extra room: 0.08 mm with the zirconia values.
- Extra room sets the room sideways and along the seating direction together. If a case holds two different numbers, the window says so; a change sets both.
- Slider ranges: Minimum thickness 0.2 to 3.0 mm, Cement gap 0.02 to 0.3 mm, Extra room 0.01 to 0.2 mm, Tight band at margin 0 to 3.0 mm. A production order can narrow them.
- A coping shows Coping wall in place of Minimum thickness: 0.5 mm by default, 0.2 to 2.0 mm.

