Set bur compensation and margin edge
Set how thick the crown ends at the margin and how the inside allows for the mill's bur.
- In the Thickness and cement gap window, scroll down.
- Margin thickness A: how thick the crown stands at the margin line.
- Open Advanced B.
Wall rise, Bur compensation and Compensation diameter appear.
- Wall rise C: the angle the wall climbs from the margin edge to full thickness.
- Bur compensation D: room inside where a round bur cannot cut a sharp corner.
- Compensation diameter E: the tool size the inside is relieved for.
Tip
- Recalculate F builds the inner surface again. On a made crown it asks first: Rebuild or Keep crown.
- A grey Bur compensation box means the case's order sets it. Change it in the order's preset.
More
- Margin thickness: 0.2 mm by default, 0 to 0.5 mm, never more than Minimum thickness. The crown's neck moves out with it; a knife edge chips in milling and sintering.
- Wall rise: 45 degrees by default, 30 to 60 degrees in steps of 5.
- Bur compensation is on for milled materials (zirconia, lithium disilicate, resin ceramic, PMMA) and off for printed resin. Compensation diameter works only while it is on.
- Compensation diameter is your bur's diameter times 1.2. For zirconia it is also divided by the blank's enlargement (1.23), because the blank is milled larger than the crown.
- Default Compensation diameter: zirconia 0.98 mm (1.0 mm bur), lithium disilicate 1.32 mm (1.1 mm bur), resin ceramic and PMMA 1.2 mm (1.0 mm bur). Range 0.3 to 3.0 mm.

