Close holes and repair a scan
Fill gaps inside the scan and clean up broken faces before you design.
Before you start
- Edit Mesh is open on the scan: right-click it and choose Edit mesh….
- Mark the faces around the hole, or press Select all A.
- Press Close holes B.
The status line reads Closed safe interior holes.
- Open More tools C.
- Press Repair D.
A report lists each fix the repair made.
- Press Apply to keep the changes.
Tip
- A hole closes only where the faces around it are marked.
- The open outer edge of the scan always stays open.
More
- Limit hole size E: off by default, so every safe hole inside the marked area is filled.
- Tick it to fill only holes whose rim is at most as long as the number F. Default 15 mm, from 1 to 100 mm.
- Repair welds duplicate points, drops loose fragments, splits faulty corners and closes pinholes on the whole scan.

