Add a printed hinge
A hinge printed with the models joins the upper and lower model at the back.
Before you start
- Both jaws in the case. The hinge needs the upper and the lower model.
- In Print models, check that Hinge A is on.
- Press Make print models.
The hinge B is built at the back of both models.
- Turn the view to the back to check the hinge.
- No hinge wanted? Press Hinge again before you make the models.
Tip
- The tile stays grey when the case has one jaw only.
More
- A new pair starts with the hinge on. Models you already made keep their choice.
- To move it by hand, switch Automatic off. Then: Drag to move · Ctrl+drag to turn · Shift+drag to tilt.
- Back to automatic puts it back where the app placed it.

