Add, replace or remove a scan
Swap a scan file, add a pre-op scan or drop the opposing scan in one window.
- On the view tools, press Manage scans A.
The Scans window lists every scan of the case.
- On the scan's row, press Replace scan B or Add scan C.
- Drop an STL, OBJ or PLY file on the box D, or click it.
The new file loads into that row.
- To take a scan out, press Remove scan E.
- Press Remove to confirm.
The row says No scan. Undo brings it back.
- If the case has one jaw only, tick No opposing scan for this case F.
Bite and Jaw motion are switched off for this case.
Tip
- Scan textures G shows or hides the scan colours on every scan.
More
- Working scan: the prepared jaw. It can be replaced but not removed.
- Opposing scan: the other jaw. It can be replaced or removed.
- Pre-op: the jaw before preparation, kept for reference. After adding it, press Align to working scan on its row.
- Replacing the working scan clears its margin lines and the crown placement. Undo restores the previous scan and design.
- The window also opens from the right-click menu: Manage scans….

