Print models with a loose die
A solid arch keeps the contacts; the loose die shows the margin clear.
Before you start
- The crown made and its margin accepted.
- In the Crown window, press Make print models.
The Print models window opens.
- Under Dies, on the tooth’s line, press Loose die A.
- Keep Solid B so the arch holds the contacts.
- Press Make print models C.
The models build; Cancel stops them.
- Check the loose die D beside the lower model.
The crown sits on the solid arch; the die is the prepared tooth on a shaft.
- Press Done.
The models and the die are saved to the case.
Tip
- Models made before? The button reads Make again.
- To see the die alone, hide Upper model and Lower model in Layers.
More
- Loose die: a solid arch for the contacts, plus a separate die with its margin clear. Fit the crown margin on the die, then check contacts on the arch.
- Removable die: the die is cut out of the arch and lifts out of its socket.
- With several crowns, set each tooth on its own line, or use Same for all teeth.

