Make print models
Models and dies from the crown case in one press. The settings start filled in.
Before you start
- The margin accepted for at least one crown, and no tool left open.
- In the Crown window, press Make print models.
The Print models window opens, already filled in.
- Under Dies A, choose the die for each tooth.
- Choose the body B: Solid, Hollow or Honeycomb.
- Pick a base height C, or keep the one shown.
- Press Make print models D.
Each model reads Building…; Cancel E stops it.
- When the models stand on screen, press Done.
The models are saved to the case.
Tip
- The same window opens from Make models in the Export sheet and from Project → Print models.
- Hinge joins both models with a printed hinge: next lesson.
More
- No die: the arch models alone. Removable die: a sectioned arch; the die lifts out of its socket. Loose die: a solid arch for the contacts, plus a loose die with its margin clear.
- Same for all teeth sets every tooth at once. Your last choice comes back; a first case starts with a loose die.
- Body: Solid is filled, Hollow is hollow, Honeycomb is hollow and braced inside. It starts Hollow, or Solid once a die is chosen.
- Base height C: the base under the gums. 3 mm, or the base that makes the taller model 25 or 30 mm high. The number below is the base now; default 5 mm.
- In the scene, each model shows its full height and its base, in mm.
- Automatic F: on, one press makes everything. Off opens the editor, where you set every step by hand.
- Text G: the patient's name on the front of both models. Type your own words or press a case chip below it.
- Half H: prints only the working half. The arch is cut on the midline and the other half is dropped.
- Printer & resin I: the settings for your printer. Standard settings until you pick one.

